TTL Output

TTL is only applicable to V3D and Zion.

Sixteen channels of ttl output can be applied to any scene in a show, the primary design behind the ttl output was for control of beam table and down-range effects, but the ttl output can be used for the control of any device that accepts the ttl protocol.

Under Output triggers select any of the sixteen outputs by left clicking on the output trigger values from 1-16, select the output triggers that you wish to use.

Multiple outputs can be sent to various devices, these are sent on a scene by scene basis, with 1 to 16 channels being sent at any one time.

To set just ttl outputs in a show click on the beam table editor, this function allows you to set a scene with only ttl outputs.

Remember to save the adjustments by clicking on save and saving the show.