 |  |
|
|
From here you can adjust all of the parameters for the projected image, add or subtract blanking points, adjust the speed at which your animation runs, etc. Wherever you see this Tab these offsets can be added or subtracted.
Frames/Second = Speed at which an animation runs. Scan Speed = Speed at which the laser beam moves from point to point. Blanking Points = The number of points repeated for each point in an image. Anchor Points On = The number of additional points laid down at the beginning of an image. Anchor Points Off = The number of additional points laid down at the end of an image. Angle Points = The number of additional points laid down on corners or angles in an image. Point Spacing = The distance between the visible points in an image. Blank Spacing= The distance between the blanked points in an image. Breaking Points = Additional points laid down to where visible and blanked lines intersect. Colour Skew = Timing offset to allow correction of different speed graphics for different hardware projectors.
|
Questions or problems regarding this help should be directed to [laserelectronics@btconnect.com]. |
